Note Mi Redmi Note 5 Pro ( m1803e7sg) Frp
Mi Note 5 Edl Point – Rest With UMT Tool [SUCCESS REPORT]
mi note 5 edl point – Operation : Reset FRP
Checking for existing devices…Not Found
Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.
Some phones may need Special Boot Cable or TestPoint for EDL mode.
Found Port : Qualcomm HS-USB QDLoader 9008 (COM3)
Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2
- Connecting to phone…OK
- Waiting for response…OK
- Init Handshake Sequence…OK
- Hardware ID : E1C00C00 [8996] 00000000
- OPK_DATA : F7337FE47B192EF4D1BA34CB4E879F0C6B771D06D2DE87BF21 F65BA3303834E1
- Initializing Protocol…OK
- Using Auto Loader Selection [1]
- Preparing Firehose Loader…Done
- Sending Loader [8996_016.ufl]…Done
- Executing Loader…OK
- Detecting Chip Type…OK
- Hardware : MSM8996, eMMC, 64 GB
- LU Count : 1 [0x0747C000]
- WARNING! High Speed Driver is not installed.
- Please install driver from QcFire\Drivers folder using Device Manager.
- Payload Info : In: 65536 [4096], Out: 131072, Sector Size: 512
- Reading Partition Table…OK
- Reading Device Information…OK
- Device : Xiaomi Redmi Note 5 Pro
- Software : OPM1.171019.011, V9.5.13.0.OEIMIFA [Wed May 30 23:54:19 WIB 2018]
- Android Ver. : 8.1.0
- Patch Level : 2018-05-01
- Resetting FRP Lock…….Done
- Operation Finished.
Mi Note 5 Test Point Failed! [Answered]
- Platform: XIAOMI
- Selected model: REDMI NOTE 5
Kindly, choose one of the alternatives for operation ‘Reset Mi Account’ or press Ok to proceed to the next step.
Navigate to the option Wi-Fi Settings and Forget the already connected wifi or do a Wipe Data from recovery instead.Put the phone into EDL mode:
- Attach testpoint as shown in Help manual;
- Connect USB cable;
- Release testpoint after 3-5 seconds.
- Found phone on COM19
- Mode: Qualcomm 9008
- Connecting…
- Reading info…
- QC HW ID: 000CC0E100000000
- CPU: Snapdragon 636 SDM636
- QC SW VER: 00000003
- Searching loader…
- Sending loaders…
- Loader send successfuly.
- Reconnecting…
- Chip SN: FFFFDFEF
- Checking request..
- Authentication is not available at the moment for any operation!
- Operation was failed!
- Performed by 1.9.4.0 Software version.