Blog Post

Detech Source > Blog > Technology > Mi Note 5 Edl Point
Mi Note 5 Edl Point

Mi Note 5 Edl Point

Note Mi Redmi Note 5 Pro ( m1803e7sg) Frp

Mi Note 5 Edl Point – Rest With UMT Tool [SUCCESS REPORT]

mi note 5 edl point – Operation : Reset FRP

Checking for existing devices…Not Found

Turn Off phone, hold Vol UP + Vol DOWN and insert USB cable.

Some phones may need Special Boot Cable or TestPoint for EDL mode.

Found Port : Qualcomm HS-USB QDLoader 9008 (COM3)

Driver Info : Qualcomm Incorporated, qcusbser.sys, 2.1.2.2

  • Connecting to phone…OK
  • Waiting for response…OK
  • Init Handshake Sequence…OK
  • Hardware ID : E1C00C00 [8996] 00000000
  • OPK_DATA : F7337FE47B192EF4D1BA34CB4E879F0C6B771D06D2DE87BF21 F65BA3303834E1
  • Initializing Protocol…OK
  • Using Auto Loader Selection [1]
  • Preparing Firehose Loader…Done
  • Sending Loader [8996_016.ufl]…Done
  • Executing Loader…OK
  • Detecting Chip Type…OK
  • Hardware : MSM8996, eMMC, 64 GB
  • LU Count : 1 [0x0747C000]
  • WARNING! High Speed Driver is not installed.
  • Please install driver from QcFire\Drivers folder using Device Manager.
  • Payload Info : In: 65536 [4096], Out: 131072, Sector Size: 512
  • Reading Partition Table…OK
  • Reading Device Information…OK
  • Device : Xiaomi Redmi Note 5 Pro
  • Software : OPM1.171019.011, V9.5.13.0.OEIMIFA [Wed May 30 23:54:19 WIB 2018]
  • Android Ver. : 8.1.0
  • Patch Level : 2018-05-01
  • Resetting FRP Lock…….Done
  • Operation Finished.

Mi Note 5 Test Point Failed! [Answered]

Mi Note 5 Edl Point

  • Platform: XIAOMI
  • Selected model: REDMI NOTE 5

Kindly, choose one of the alternatives for operation ‘Reset Mi Account’ or press Ok to proceed to the next step.

Navigate to the option Wi-Fi Settings and Forget the already connected wifi or do a Wipe Data from recovery instead.Put the phone into EDL mode:

  1. Attach testpoint as shown in Help manual;
  2. Connect USB cable;
  3. Release testpoint after 3-5 seconds.
  • Found phone on COM19
  • Mode: Qualcomm 9008
  • Connecting…
  • Reading info…
  • QC HW ID: 000CC0E100000000
  • CPU: Snapdragon 636 SDM636
  • QC SW VER: 00000003
  • Searching loader…
  • Sending loaders…
  • Loader send successfuly.
  • Reconnecting…
  • Chip SN: FFFFDFEF
  • Checking request..
  • Authentication is not available at the moment for any operation!
  • Operation was failed!
  • Performed by 1.9.4.0 Software version.
Spread the love